| |
-
Bit of a late reply but I have a '98 same question ??
Thanks
-
Hi
Can you change the crank seals on a '98 315 without splitting the cases???
Thanks
-
Haha snatching I meant !!! Although if I like a snicker bar !!! Th x will try carb clean then coil ! Btw was ok for a while until warmed up????
-
Hi all,
Been out today on my 315 it was snacking a bit but running ok ,then it just died restarted but soon as under load died again ....repeat !!! Any ideas ?thanks
-
Good call ,compressed fork and job done !!! Thanks
-
-
Also is it 5w oil, and how much per fork ??
thanks
-
Hi,
I'm having problems releasing the retaining bolt on the bottom of my 315d's left hand fork (compression) it is just spinning ,is there a knack to holding the innards ??
Thanks
Paul
-
Thanks Pete I'll investigate
-
Hi all,
After fitting a new clutch\water pump gasket to cure a small leak ,I ran the bike,started fine ,revved ok after maybe 2/3 minutes stopped firing (but still running very lumpy)and water entered the gearbox!!! When I remove the water pump seals etc ok removed clutch cover gasket ok,but Mick start shaft loose!!!! What's happened any ideas ????
Gasgas 125 txt pro 2009
Thanks in advance
Paul
-
-
Hi guys,
What grade of fork oil do I need (txt 125 pro 2009) ,how do I make sure cartridge is full and how much oil do I need? Thanks
-
What about a rack with a trials bike on and a trailer with another ? Using an insignia estate 2ltr diesel????
-
Hi all,
My son has a g/g 125 txt pro 2009 I'm wondering as I'm changing front fork seals ,is the rear shock serviceable?? As it's 11 years old now ??
Thanks
-
On the I'm gonna strip clutch and have a look .not sure which fluid not changed it since had bike!!
-
Hi thall,
400 ml I may put another 50 in then ! Fluid a bit low in m/cyl ! Cause?
Thanks
-
Hi all,
My son has a 2009 gas gas 125 txt pro , last time sewers out of ran fine, just changed gearbox oil,ready for tomorrow started it up ,and it has a knocking sound which when clutch lever is pulled in stops, also when put into gear stalls ( drag??) Any ideas
Thanks Paul
-
Thanks that's sorted !! Cheers
-
Thanks Bilko,
I take it I'm looking at cylinder head screws?
-
Hi guys , anyone know the torque settings for the cylinder head on a 2009 txt pro 125 !
Thanks
-
Thanks that's what I'm hoping,not had time to look yet cheers
-
No it deffo comes outta crank case /gearbox!! Thanks
-
Hi collyolly, yes bike was running fine, just finished the day, wasn't dropped, just a sudden drop of power when restarted!
-
Thanks dabster, I did think that but thought I'd ask ! I'll strip carb and see!! Thanks
-
Hi all,
My son was competing yesterday on his gas gas 125 txt pro 2009 and and it lost power ,still running but no power to speak of!! My first thoughts were water in the carb but after having a look this afternoon found the right angled breather connecter ( just in front of front sprocket)was broken would this be the cause ???
Thanks
|
|
