Hi guys , just replacing the kickstart assembly on my vertigo vertical, and can't get the kickstart to return, do I need to take the clutch off for re assembly, did it about 2 yrs ago but can't remember what I did
Thanks very much, it also looks like that I might need a stepped rubber to manifold, according to in motion website, so will order one of those, I used the straight one from the 159 to try it,,,, would that make much difference
Hi triasrfun, I have a 159 sherpa, I had a carb built to your above spec and bike runs spot on,,,, I have a 78 350 too, rebuilt to 340 cc, carb is lean on bottem end with these settings, shall I just richen it up with bigger pilot jet, or does this bike need all different settings, ps is Bob on on power, thanks
can anybody help . i have a rev4t 08 . thats bad to start, fouling plug up , and struggles to rev clean. i have .......... re jetted carb,re set valves, had stator re wound, thouroughly cleaned out all carb and choke jets,new plugs, clean air filter, altered air screw , breather pipes clean