johnny_rotten_dab Posted December 20, 2006 Report Share Posted December 20, 2006 (edited) Edited December 16, 2020 by johnny_rotten_dab Quote Link to comment Share on other sites More sharing options...
big red Posted December 21, 2006 Report Share Posted December 21, 2006 I AM NOT A EXPERT...I have the same bike and I've heard that the "sag" is 1/3 of the travel of the suspension. I don't know how much you weigh ?? Rear end stiff ??? Check how much the rear spring is "turned down". Good luck, Jim Quote Link to comment Share on other sites More sharing options...
anotherfatbastard Posted December 24, 2006 Report Share Posted December 24, 2006 (edited) Put your bike up on a stand/bucket so the weight of the bike is on the skid plate. Use a measuring tape to beasure from the rear axel to the screw holdong your rear fender on. Then take the tape measure and measure the fron axel to the crown. Put on your riding gear (to get a better weight measurment) and stand on the bike with the tires on the ground, get someone to measure the same spots again (this is your pre-sag), tighten of loosen the springs untill you get around 3 inches. For an more advanced rider it should be 2 1/2 inches, int to beginner go 3 to 3 1/2 inches max. Have fun Jason Heidrick Edited December 24, 2006 by anotherfatbastard Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.