uhoh7 Posted May 30, 2007 Report Share Posted May 30, 2007 (edited) Anyone have the specs handy for how much fluid the rad, hoses and water pump hold? I'm experimenting with water wetter: trying to figure how much to add.... ty sirs last week........it's getting good now Edited May 30, 2007 by uhoh7 Quote Link to comment Share on other sites More sharing options...
stkman Posted May 30, 2007 Report Share Posted May 30, 2007 Can't help you with the coolong system specs but have to say, great job on the extra capacity tank and the seat. Great looking place to ride ... very nice. Looks like the perfect setup for bike and location, Andrew Quote Link to comment Share on other sites More sharing options...
fetona Posted May 30, 2007 Report Share Posted May 30, 2007 Where did you get your seat? And how do you like it? Anyone have the specs handy for how much fluid the rad, hoses and water pump hold?I'm experimenting with water wetter: trying to figure how much to add.... ty sirs last week........it's getting good now Quote Link to comment Share on other sites More sharing options...
uhoh7 Posted May 31, 2007 Author Report Share Posted May 31, 2007 Where did you get your seat? And how do you like it? hehe I'm not telling till somebody answers my question..... Quote Link to comment Share on other sites More sharing options...
spinner Posted May 31, 2007 Report Share Posted May 31, 2007 I use a cap full in both of our Pro's Great pictures!!!!!!!!!!!!!!!!!! Quote Link to comment Share on other sites More sharing options...
fetona Posted May 31, 2007 Report Share Posted May 31, 2007 I looked around and could not find the spec for the cooling system capacity. Your best bet will be to drain your cooling system and measure how much fluid comes out. I found this on the GG website regarding the radiator cap: The cap is a pressure type cap that helps to pressurize the system. This reduces cavitation at the water pump vane and raises the boiling point of the coolant two degrees for each pound of pressure. If there are no other signs of overheating, it may have lost some tension so what you may want to try first is to add a large o-ring that just fits into the radiator neck. This will take up the clearance. Make sure the flat rubber gasket is in good shape so it seals well. Add coolant just up to the bottom of the neck to allow some room for expansion when the coolant heats up. If overfilled, it's normal for the radiator to release some coolant when the engine warms up. Quote Link to comment Share on other sites More sharing options...
cdn280 Posted June 1, 2007 Report Share Posted June 1, 2007 (edited) I'd go with 1 cap full. I used 2 caps in a 640 KTM and 3 caps in a VFR and it dropped the temp in the VFR by 8-9 degrees C. Now where did you get that tank/seat ! I think I recall it was France, but where and how much ? btw - the capacity is less than 1 litre Edited June 1, 2007 by cdn280 Quote Link to comment Share on other sites More sharing options...
miner Posted May 17, 2018 Report Share Posted May 17, 2018 Just put the last of my Motul Mocool in my GG, found this thread useful as its not in the manual... Quote Link to comment Share on other sites More sharing options...
cascao Posted May 17, 2018 Report Share Posted May 17, 2018 Sherco hold 450cc as manual says. Gasgas sould be close 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.