Jump to content

Ty250 Mono Not Revving Cleanly


mickh
 Share

Recommended Posts

at a trial on sunday i found that when i first opened the throttle the engine hesitated at first then as the revs rose it cleared and revved perfectly. the carb has been cleaned jets blown out etc and a new plug fitted.

any help would be greatly appreciated

mickh

Link to comment
Share on other sites

 

I used to have a TY that got a bit confused until i really cleaned the exhuast out, as in the whole exhuast, not just the silencer. I cut the front off the middle box, burnt out loads of gunk and carbon with a gas torch then repacked it, it ran really well after that. You don't have to cut the front off the box though, running a gas flame through it untill it's really hot does the same, but it did let me see what a state it was in, all the holes in the baffle were clogged and the diameter had narrowed quite a bit. The confused running was a problem that crept up slowly, not one that suddenly appears so not sure if it's your problem.

Link to comment
Share on other sites

 
 

Clean the carb again? B)

Air filter obviously but I'm sure you've done that.

It sure sounds like a blockage in your pilot jet.

If you have good spark, good air, good fuel then could the timing have slipped? I've heard of woodruff keys shearing allowing this to happen but to be honest I have no idea what one is or even if a TY has one!

Link to comment
Share on other sites

 
 

Fuel height in the float chamber is critical. Too high and it'll sound like its choking up on up to quarter throttle, beyond that its fine.

Can't remember the measurements but I'll try and dig out the manual

Eiger

Link to comment
Share on other sites

 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...