brendan Posted November 30, 2008 Report Share Posted November 30, 2008 I somehow lost the ball that goes in between the two clutch push rods. Does anyone know what the diameter of the ball is? I am hoping to find the right sized ball bearing at a hardware store. thanks. Quote Link to comment Share on other sites More sharing options...
copemech Posted November 30, 2008 Report Share Posted November 30, 2008 Best I recall it was the same diameter as the rods! Whatever that is! Quote Link to comment Share on other sites More sharing options...
arnoux Posted November 30, 2008 Report Share Posted November 30, 2008 put the verniers on the rod - it's the same OD. Or try Yamaha dealer part number: 93505-16006 PS. tried responding to your mail, but your email address no worky! Quote Link to comment Share on other sites More sharing options...
b40rt Posted November 30, 2008 Report Share Posted November 30, 2008 Also try cycle dealers who might have a similar sized bearing Quote Link to comment Share on other sites More sharing options...
brendan Posted December 1, 2008 Author Report Share Posted December 1, 2008 Thanks, Paul & everyone. I did as advised, and a 5/16" ball bearing seems to match. I was able to find one of those at Orchard Supply Hardware. One thing, though, it looks like the two push rods are different diameters. I measured the outer rod that pushes on the pressure plate, as I could not get the inner one out. The inner rod looks like it is a smaller diameter. Anyone remember if their clutch ball bearing was the same size as the outer rod or inner? Paul, I do not know why my email address is giving problems. I have a received a few emails today. Thanks for catching me on this board, though. Quote Link to comment Share on other sites More sharing options...
dfwilson Posted December 1, 2008 Report Share Posted December 1, 2008 (edited) Thanks, Paul & everyone. I did as advised, and a 5/16" ball bearing seems to match. I was able to find one of those at Orchard Supply Hardware. One thing, though, it looks like the two push rods are different diameters. I measured the outer rod that pushes on the pressure plate, as I could not get the inner one out. The inner rod looks like it is a smaller diameter. Anyone remember if their clutch ball bearing was the same size as the outer rod or inner?Paul, I do not know why my email address is giving problems. I have a received a few emails today. Thanks for catching me on this board, though. Take a look at the ends of the rod there will be polished indentation in one end of the rod made by the ball. Edited December 1, 2008 by dfwilson Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.