totalshell Posted March 31, 2009 Report Share Posted March 31, 2009 other than the nut on the left side is the spindle threaded or does it just 'slide in and tighten on the nut. trying to get it out nuts off but do i whack it good and proper or is it screwed in.. must come out tonite.. cheers Quote Link to comment Share on other sites More sharing options...
bob Posted March 31, 2009 Report Share Posted March 31, 2009 Hi, Had mine out a while ago, and took my mates out on Saturday, it is just the bolt with a washer and a nut on the end, so it will bash through. Bear in mind it isn't the toughest material though when you bash it through, and you'll probably find that jiggling with the swinging arm and maybe even loosening off the engine mountings at the back will give it a bit more movement if it is really tough to come out. Best of Luck, Bob Quote Link to comment Share on other sites More sharing options...
totalshell Posted March 31, 2009 Author Report Share Posted March 31, 2009 cheers for that, the hex head of the bolt is a little soft and i was worried it might be mush by the time i got it turning. now i know it'll push out i'll be outside with a yorkshire screwdriver... Quote Link to comment Share on other sites More sharing options...
totalshell Posted April 1, 2009 Author Report Share Posted April 1, 2009 wow that thing didnt want to come out.. unlike most bolts /shafts that once they start moving your on your way .. not this mother way no. it wanted to play rough and needed 2lb of persuasion for every hard fought mm still can only be one winner.. thankfully Garys got another spindle in the post as we speak Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.