tltel Posted January 30, 2010 Report Share Posted January 30, 2010 Hi just a suggestion, assuming the gear shaft set up is similar to the TL125. the shaft runs through the engine and connects to the seclter drum behind the clutch, as your engine has obviously been moved around a bit I would check here first before taking engine apart. The 10 mm nut sometimes comes undone on the end of the selecter drum so things dont engage properly. I think you can get to this without removeing the clutch basket,but not sure. good luck TLTEL Quote Link to comment Share on other sites More sharing options...
bigmike1961 Posted January 30, 2010 Author Report Share Posted January 30, 2010 Thanks, I'll try there first, The clutch cable seemed a bit dodgy (stretched) and I'm trying to work out the year for the engine to order a new one. The clutch plates were firmly stuck to start with when I first rode it but freed off with a bit of a bang so the clutch area was my first port of call. Quote Link to comment Share on other sites More sharing options...
tltel Posted February 1, 2010 Report Share Posted February 1, 2010 Hi I have recently bought clutch plate sets off ebay for TL and TLR for Quote Link to comment Share on other sites More sharing options...
bigmike1961 Posted February 20, 2010 Author Report Share Posted February 20, 2010 (edited) David Silver Spares worked out the cable needed from the engine number. However the sparks suddenly disappeared! Had a fiddle around with the pulse generator in the head and with the cover off it was generating sparks at the plug like a very sparky thing. Put the cover back on and nothing - not a sign of a spark. ordered a new pulse generator as the wiring was very tired, must be shorting out when the cover is on. I'll have to get the engine running before looking further at the gear selection problem. Thanks for the advice. Edited February 20, 2010 by BigMike1961 Quote Link to comment Share on other sites More sharing options...
bigmike1961 Posted April 14, 2010 Author Report Share Posted April 14, 2010 New Pulse generator sorted the spark out, it's running again so I can look at the gear problem. Quote Link to comment Share on other sites More sharing options...
bigmike1961 Posted May 20, 2010 Author Report Share Posted May 20, 2010 Here's a pre 180cc photo. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.