tt5th Posted May 15, 2009 Report Share Posted May 15, 2009 Does anyone know anything about respoking a 'z' spoke rear wheel from a 250 mono? I have some spokes but it seems you can't replace individual spokes due to the 'z' bit. Do I have to remove all the spokes to replace one? Or is there a special technique? Any help appreciated! John. Quote Link to comment Share on other sites More sharing options...
andy.t Posted May 15, 2009 Report Share Posted May 15, 2009 Not an expert on that type of spoke but from from experience on rebuilding ty175 wheels I would say if the spoke wont come out and if you dont want to bend it to get it out then you will have to remove others . Quote Link to comment Share on other sites More sharing options...
tt5th Posted May 15, 2009 Author Report Share Posted May 15, 2009 Oh i got it out! Angle grinder sorted that for me, just can't get the new one in. Quote Link to comment Share on other sites More sharing options...
lineaway Posted May 16, 2009 Report Share Posted May 16, 2009 It has been too long to remember, but you will have to loosen and maybe remove a few. The sequence was like every 4th one. Good luck with the stuck nipples. Quote Link to comment Share on other sites More sharing options...
tt5th Posted May 16, 2009 Author Report Share Posted May 16, 2009 Nipples are no problem as i have a full set of new ones but it is looking like i'm going to have to take out a few more than i wanted too! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.