ukmarra Posted June 17, 2009 Report Share Posted June 17, 2009 Hi all, out riding my 250 techno yesterday, the rear brake became stuck on. The brake pedal was fully depressed (out) but it was still locked on. I freed it by giving it a "gentle" kick only for it to stick on again later. Getting back to the car, the pads were as you can imagine quite smelly and hot. Any ideas as to why they would just lock on themselves? Cheers Quote Link to comment Share on other sites More sharing options...
laser1 Posted June 17, 2009 Report Share Posted June 17, 2009 not a beta expert, but one thing is that draging the brake will heat up the fluid to the point of boiling - hence expanding and locking on the brake. Water in the system will make it even worse. I would flush my rear brake system with fresh fluid and figure out why it was draging. (I like dot5 for its high boiling point) Quote Link to comment Share on other sites More sharing options...
ruffrider Posted June 17, 2009 Report Share Posted June 17, 2009 I'd strip the calliper down and check that the pots move freely. Quote Link to comment Share on other sites More sharing options...
stevie2212 Posted June 17, 2009 Report Share Posted June 17, 2009 Hi all, out riding my 250 techno yesterday, the rear brake became stuck on. The brake pedal was fully depressed (out) but it was still locked on. I freed it by giving it a "gentle" kick only for it to stick on again later. Getting back to the car, the pads were as you can imagine quite smelly and hot. Any ideas as to why they would just lock on themselves?Cheers had the same thing on my 4rt it was a hot day fluid expanded looked on brake change fluid give it some more freeplay on the pedal and bobs your mothers brother Quote Link to comment Share on other sites More sharing options...
ukmarra Posted June 17, 2009 Author Report Share Posted June 17, 2009 Thats great, thanks for all the replies it really helps being a 'newbie'. The thing with the dot 5 fluid, the system says only use dot 4 does it really matter? Thinking back too, there were loads of steep down hills where i was riding which would explain the fluid heating up to boiling point! Quote Link to comment Share on other sites More sharing options...
braddon Posted June 28, 2009 Report Share Posted June 28, 2009 If none of that works you may want a new brake hose. Something on the inside of the hose can wear out or something and block the return flow of brake fluid. I had this problem on my front brake, replaced the hose and was fine. Quote Link to comment Share on other sites More sharing options...
slapshot 3 Posted June 28, 2009 Report Share Posted June 28, 2009 STRONGLY suggest to strip your back caliper out it's most likely to be crapped up pistons, get a new piston/seals kit from Lampkins refit and all should be well. Quote Link to comment Share on other sites More sharing options...
kevin j Posted June 29, 2009 Report Share Posted June 29, 2009 make sure the master cylinder stroke is correct. If the lever stroke is too short or piston is in too far, it does not allow the bleed port to uncover and allow fluid to return to the reservoir. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.