scotty Posted June 28, 2009 Report Share Posted June 28, 2009 Hi guys, I haven't used my ty250 majesty for ages and now the clutch wont disengage! it was working perfectly before but i think the plates have stuck together ive tried using the bike clutching it now and then but it still wont work do i have to strip down the clutch assy to free the plates or can you ride the bike a certain way to unseize the clutch assembly? Thanks in advance Quote Link to comment Share on other sites More sharing options...
lee harris Posted June 28, 2009 Report Share Posted June 28, 2009 (edited) Try this. On the wheels, 5 th gear, engine off. Pull the clutch lever in and pull/jerk the bike sharply backwards. Try it 10 times or so. Works on minarelli fantic some of the time. If not they have to be stripped! HTH lee Edited June 28, 2009 by Lee Harris Quote Link to comment Share on other sites More sharing options...
tony283 Posted June 28, 2009 Report Share Posted June 28, 2009 Drain off the current oil and use an ATF. Run for about 30-60 mins periodically running with the clutch lever against the bars. As the oil soaks in it will free off and should then be fine. A very common problem with old clutches and old oils. Tony Quote Link to comment Share on other sites More sharing options...
mattylad Posted June 29, 2009 Report Share Posted June 29, 2009 Start engine, pull in clutch, point bike in direction of wide open spaces, gently snick into gear at low revs, you will now be moving forward hence previous, keep clutch in and press down on rear brake. clutch will free Quote Link to comment Share on other sites More sharing options...
tony27 Posted June 29, 2009 Report Share Posted June 29, 2009 The ty I rode at start of june had been sitting for 10 years & wouldn't free using the rocking method so I expected a strip etc. Quick thing that I tried was while the bike had rear wheel off the ground & running pull the clutch in a few times before putting in gear & using the brake a few times until it freed. Was surprisingly easy Quote Link to comment Share on other sites More sharing options...
scotty Posted June 29, 2009 Author Report Share Posted June 29, 2009 Thanks everyone i will give it a go at the weekend! Quote Link to comment Share on other sites More sharing options...
kuelmuel Posted July 16, 2009 Report Share Posted July 16, 2009 Get it running, roll it along and tread it into gear, then just work your way up to 3rd or 4th. (You can change gear easily without the clutch if you're gentle). Then hold the clutch in, and accelerate hard until it starts to slip. Used to work on our old 175 twinshock! Quote Link to comment Share on other sites More sharing options...
scotty Posted August 14, 2009 Author Report Share Posted August 14, 2009 Thanks Lee, Worked a treat! Had a go on the old girl today was thinking of selling it but can't bear to part with it, the Beamish would have to go first if i had to sell one Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.