tyben Posted July 19, 2009 Report Share Posted July 19, 2009 I have a yamaha ty175 and the clutch lever has to be let almost right out before it engages. I have tightened the adjuster on the handlebar in as far as it will go and it still is to far out to be able to control it properly when riding. Is there anyway of adjusting it more maybe on the engine end so that it engages a few centimetres from the handlebar. Thanks Quote Link to comment Share on other sites More sharing options...
gazzaecowarrior Posted July 19, 2009 Report Share Posted July 19, 2009 You can gain a bit more adjustment from the cable itself. There are adjusters at the top of the cable. Then if that is still not sufficent, take off the flywheel cover and you will see a nut with a little cross headed bolt sitting inside it. This is situated roughly below where the clutch arm goes into the crankcases. This is the clutch release mechanism. The Haynes manual has a good section on how to set it. Best of luck. Gaz Quote Link to comment Share on other sites More sharing options...
tyben Posted July 20, 2009 Author Report Share Posted July 20, 2009 Thanks i will give that a try. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.