jsndenny1 Posted August 15, 2009 Report Share Posted August 15, 2009 hi , just rebuilt my engine having had a gearbox rebuilt, the engine is back together and placed back into the frame of the bike , came to bleeding the clutch and cannot get a response in the pull of the lever .after re-bleeding the clutch , Sometimes i will get a tough and solid pull which makes the lever not moveable what so ever can somebody send me a diagram so i can see if it is assembled properly ? Thanks Jay. Quote Link to comment Share on other sites More sharing options...
no1 Posted August 15, 2009 Report Share Posted August 15, 2009 between the the 2 rods inside the shaft have you put the ball bearing in Quote Link to comment Share on other sites More sharing options...
hermancremer Posted September 16, 2009 Report Share Posted September 16, 2009 jsndenny1 i am busy rebuilding my gearbox on my trials bike (Rev3 290) did you work from a assembly manual as a guide. I am battling a bit with the reassembly and want to make 100% sure all is assembled properly before starting her up again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.