ssdt1980 Posted April 6, 2010 Report Share Posted April 6, 2010 Hi How do you de-coke a front exhaust pipe on a 156 Fantic, I think it would help perfornmance if I could do this, after 30 years it must be well gundged up, but I haven't a clue how to go about it, is caustic soda any good? Cheers, Tony Quote Link to comment Share on other sites More sharing options...
anyoldiron Posted April 6, 2010 Report Share Posted April 6, 2010 If you are handy with a welder,the best way may be to cut it open at its wider section and clean it from within.and weld it up againIf not,caustic soda is an option.Burning all the oily gunge out can help too. Quote Link to comment Share on other sites More sharing options...
somerset steve Posted April 6, 2010 Report Share Posted April 6, 2010 Hi there. (before i leave this H&S dictates i take no responsibility if you singe your eye brows). I would go with the burn out option. If you get it off the bike, take some petrol, fill it then leave it too soak over night. Pour out the petrol, put too one side. Take a lighter and set light to one end. If you have a compressor gently blow down one end, you should have a flame thrower effect out of the other end, you really must do this out side, take great care. When nice and hot give it a couple of good taps with a hammer, the carbon should fall out. Good luck. Quote Link to comment Share on other sites More sharing options...
lee harris Posted April 13, 2010 Report Share Posted April 13, 2010 If you burn out this way, you will destroy all the steel wool packing in the silencing part for the chamber. Thats ok but then needs cutting open and repacking. Look at the exmoor video clip at my 200..its loud lee Quote Link to comment Share on other sites More sharing options...
somerset steve Posted April 13, 2010 Report Share Posted April 13, 2010 Can you send a link to the video \Lee? Steve Quote Link to comment Share on other sites More sharing options...
furse Posted April 13, 2010 Report Share Posted April 13, 2010 I prefer the burnind out then cut it open ditch all the steel baffles that are probably loose by now and let ir roar! Using petrol and air may be a bit extreme, i'd soaked in oil and burn for 10 mins in a steel fire bucket, bit safer may be. Another method but not as effective is to get an old clutch cable inner and split/ fray the end fold it over push it into the pipe the put the other end into an electric drill and spin away, becareful it doesn't snag and twist, you could use a cordless on torque setting I supose. Quote Link to comment Share on other sites More sharing options...
lee harris Posted April 14, 2010 Report Share Posted April 14, 2010 Can you send a link to the video \Lee?Steve Steve, its on here, exmoor classic trial videos and piccies Lee Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.