Jump to content

gas gas stator and flywheel


wrmec
 Share

Recommended Posts

hello. i have an 06 gas gas txt pro that i am goin to fit a new stator to. i was wondering is this a big job to do. i think fitting the stator is just a case of fixing it in and when i put the flywheel back on is it just a case of bolting it in or does it need setting? thank you for any replies.

Link to comment
Share on other sites

 

hello. i have an 06 gas gas txt pro that i am goin to fit a new stator to. i was wondering is this a big job to do. i think fitting the stator is just a case of fixing it in and when i put the flywheel back on is it just a case of bolting it in or does it need setting? thank you for any replies.

No need to set anything as the stator is "fixed" in place. You might want to clean the areas where the stator contacts the engine cases, add a little blue Loctite to the flywheel bolt and torque it to 30 to 32 Ft lbs/40 to 42 Nm. I'd check the torque of the bolt after you've ridden it a couple of times and then you should be set.

Jon

Link to comment
Share on other sites

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...