Jump to content

Grphics


adam28
 Share

Recommended Posts

 

you and get two of your mates to help especially if it's the back mudguard

and lots of masking tape to keep it in place.

first you want to warm the area with a hair dryer and the sticker, start around the light and push all the bubbles out, you will need to peel the backing sheet of a little at atime and pull and stretch the sticker until it's all on be carefull not to rip the sticker near the seat as it's only thin.

hope this helps

also clean the plastic mudguard with some white spirits

Link to comment
Share on other sites

 
 
 
 

I mix part water and a bit of fairy liquid, then heat the sticker and the mudguard with a hairdryer, brush a little bit of fairy liquid on and then peel all the backing off of the sticker, put it on the mudguard then move it around on the water until its in the right place, then with your hairdryer move up and down the sticker so that the water evaporates and :rolleyes: a sticker very well fixed just where you want it.

Lloyd

Link to comment
Share on other sites

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...