bobbylovely Posted June 1, 2012 Report Share Posted June 1, 2012 I have just changed the clutch plates on my 06 Raga 300. I replaced the 2 o rings and bleed out the system. It all runs and gears engage fine but when its i pull the clutch in, and stand stationary the bike still seems to want to drive forward. Any suggestions. Could it need adjustment if so how do I go about it. Or could it still be air in the system. Quote Link to comment Share on other sites More sharing options...
neilh Posted June 1, 2012 Report Share Posted June 1, 2012 does it still do it when the bike has been run up to temp? Quote Link to comment Share on other sites More sharing options...
chris91 Posted June 1, 2012 Report Share Posted June 1, 2012 what reason did you change the clutch for? is is doing the same thing as before? Quote Link to comment Share on other sites More sharing options...
bobbylovely Posted June 2, 2012 Author Report Share Posted June 2, 2012 Was advised to change the clutch as it was slipping, and no it didn't do this before only since the change. To be honest its been nothing but trouble give me my old beta back Quote Link to comment Share on other sites More sharing options...
alvin123 Posted June 2, 2012 Report Share Posted June 2, 2012 Make sure your leaver has clearence. Quote Link to comment Share on other sites More sharing options...
chris91 Posted June 2, 2012 Report Share Posted June 2, 2012 Also wat oil u using? ATF has been known to swell plates making clutch drag. You will also alway get a small amount of drag with the Gas Gas. So I have been told Quote Link to comment Share on other sites More sharing options...
steve_e Posted June 2, 2012 Report Share Posted June 2, 2012 Mine creeps slightly after changing to atf. I prefer a really aggressive bite and I did't like the feel when running on Putoline but it did not drag. I got used to the slight drag and find it easy to compensate with brakes. If you have just replaced the clutch it could be down to measurements see the videos on gg usa. Quote Link to comment Share on other sites More sharing options...
chris91 Posted June 2, 2012 Report Share Posted June 2, 2012 Pack width should be between 9.75 and 9.85 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.