moocher22 Posted February 20, 2013 Report Share Posted February 20, 2013 Hi putting back a 200 engine and I cannot work out how spring goes on gear selector shaft any help much appreciated or even a picture before hammer gets taken to it damn bikes Quote Link to comment Share on other sites More sharing options...
zerorev3rev4 Posted February 20, 2013 Report Share Posted February 20, 2013 said you would have fun ,,its hard to describe but ill have a go ,, with the selector out in your hand the spring goes on both legs down to the end the legs go either side of a metal tab without crossing each other probably spreading the legs apart , then when you slide it in ( this sounds like its from a porn mag) the long bolt that pertrudes the inner casing fits inbetween the spring so when the shifter is moved up or down the spring returns it to its center position ,, remeber to align the dots up on toothed arm and cog ,, also check clearence on all parts when fitting the circlip on left side also fit a washer taking up any slack ,clip needs to seat well and be tight fit Quote Link to comment Share on other sites More sharing options...
moocher22 Posted February 21, 2013 Author Report Share Posted February 21, 2013 Cheers my problem is the part were spring ends go on I'm not sure if its bent as if you look at parts pictures its like 90 degree angle were this one seems to be bent round to right a bit and that's why I think spring just comes off Quote Link to comment Share on other sites More sharing options...
moocher22 Posted February 21, 2013 Author Report Share Posted February 21, 2013 Another one is the dots that need to be lined up on arm and cog would that be in neutral Quote Link to comment Share on other sites More sharing options...
zerorev3rev4 Posted February 21, 2013 Report Share Posted February 21, 2013 yes when dots aligned that should be neutral , the tab should be 90* they often get snapped off Quote Link to comment Share on other sites More sharing options...
moocher22 Posted February 21, 2013 Author Report Share Posted February 21, 2013 Thought it was bent,when you say these snap what's the usuall outcome weld another piece on,ps you were right about the fun I would have,thanks for the help this is just the start as after engine it is forks strip and rebuild,another job I have never done--lol Quote Link to comment Share on other sites More sharing options...
zerorev3rev4 Posted February 21, 2013 Report Share Posted February 21, 2013 ive welded small allen bolts on them before which works ok Quote Link to comment Share on other sites More sharing options...
johnwayne22 Posted February 24, 2013 Report Share Posted February 24, 2013 Hi moocher, i had exactly the same problem recently. make a small tab from mild steel and weld it on. I welded mine with the selector in place.( Needs a steady hand) make sure you cover the rest of the internals though. think this photo will help. Bit untidy, but theres no way i was gonna get my grinder in there! Don't know why my photos are enormous!? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.