bulto58 Posted May 18, 2013 Report Share Posted May 18, 2013 Hi Guy's, Just gone in on my M91 and replaced, mag side crank seal, and sprocket oil seal. I noticed the clutch push rod had the concaved end facing out is this right . should it be pushing on the ball bearing on the other side ? Quote Link to comment Share on other sites More sharing options...
feetupfun Posted May 18, 2013 Report Share Posted May 18, 2013 Ball bearing end is meant to be flat. Left hand end is meant to be convex (domed outwards) Quote Link to comment Share on other sites More sharing options...
bondy Posted May 18, 2013 Report Share Posted May 18, 2013 hello yes thats normal theres a ball bearing on both ends. theres a ball bearing on the end off your clutch arm inside your magneto cover nothing to worry about. cheers bondy Quote Link to comment Share on other sites More sharing options...
pschrauber Posted May 18, 2013 Report Share Posted May 18, 2013 That's wear to the push rod done by the ball end due to too little slack of the clutch cable, or very much slipping the clutch while riding. Quote Link to comment Share on other sites More sharing options...
bulto58 Posted May 19, 2013 Author Report Share Posted May 19, 2013 Ok, Thanks for the information. cheers Guy's Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.