tworivers Posted July 1, 2013 Report Share Posted July 1, 2013 Further to my first post, I have a 175 that was starting first kick with the choke on but then when you put the choke in it died. After some advise on here I stripped the carb and cleaned and checked all the jets etc, mixed new fuel 50:1 cleaned out the tank which was full of bits of fibre glass but a new fuel hose on. Put the carb back together and the bike started fist time without choke and ticket over nicely. But when I took the bike for a spin it seemed to bog down without much power as if it was choked, then it stopped and wouldnt re start. What I have done so far. Stripped the carb again. ( wont start and backfires) Took out the new fuel and put the old fuel back in. Put the old fuel pipe back on. Put in new plug stripped and rebuilt fuel tap. Still the bike wont start. Lastly I have removed the fly wheel to check the points to find a broken wood ruff key, would it be this that's causing the problem, I only ask because it says on one of the suppliers web site that it is just for positioning the fly wheel. Should I be looking for other things or does anyone think it would be the wood ruff key. Quote Link to comment Share on other sites More sharing options...
canada280i Posted July 1, 2013 Report Share Posted July 1, 2013 Definitely the woodruff key. The flywheel has slipped which has effectively buggered the timing. Quote Link to comment Share on other sites More sharing options...
gloud Posted July 1, 2013 Report Share Posted July 1, 2013 If the key was there and in two pieces it was not for adjusting the timing. replace the key. Quote Link to comment Share on other sites More sharing options...
tworivers Posted July 1, 2013 Author Report Share Posted July 1, 2013 is the wood ruff key in 2 parts? does anyone know the dims? Quote Link to comment Share on other sites More sharing options...
nelly1 Posted July 1, 2013 Report Share Posted July 1, 2013 woodruf key is just a D shaped lump of metal that holds the flywheel in the right place Quote Link to comment Share on other sites More sharing options...
tworivers Posted July 1, 2013 Author Report Share Posted July 1, 2013 Should it just be a case of replacing the woodruff key and everything should then be back in line? Is there anything else I should check before I try to restart it. Quote Link to comment Share on other sites More sharing options...
lineaway Posted July 1, 2013 Report Share Posted July 1, 2013 Get the correct key , put it back together and see if it is all ok. You cannot run with out a key.(for long) Quote Link to comment Share on other sites More sharing options...
nelly1 Posted July 1, 2013 Report Share Posted July 1, 2013 id change the points and condenser whilst the flywheel is off and give the flywheel a really good clean but when you refit it it should be fine Quote Link to comment Share on other sites More sharing options...
charlie chitlins Posted July 2, 2013 Report Share Posted July 2, 2013 If the key was buggered, replace it, but, on our modern bikes, the flywheel triggers the spark, so its position is critical. I doubt this is the case on a bike with points. Unless the points cam is somehow part of the flywheel. Quote Link to comment Share on other sites More sharing options...
thats_a_five Posted July 2, 2013 Report Share Posted July 2, 2013 The woodruff key holds the flywheel in the correct position to the crankshaft. The points are opened and closed by the center of the flywheel so it will not run if the flywheel is not correctly clocked. Replace the woodruff key, reassemble and test. Make sure to tighten the flywheel bolt correctly. Most of the time when a key shears, it is because the flywheel bolt was loose. Quote Link to comment Share on other sites More sharing options...
tworivers Posted July 2, 2013 Author Report Share Posted July 2, 2013 Update. Thanks for everyones input and advise. I have just installed a new woodruff key and the bike started first kick, been for a quick run and everything seems good. result. Thanks again Quote Link to comment Share on other sites More sharing options...
thats_a_five Posted July 6, 2013 Report Share Posted July 6, 2013 That's good to hear. Have fun. Keep the rubber side down and the feet up! Quote Link to comment Share on other sites More sharing options...
bigmike1961 Posted July 13, 2013 Report Share Posted July 13, 2013 That's good to hear. Have fun. Keep the rubber side down and the feet up! I like that. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.