littleblackflash Posted July 4, 2013 Report Share Posted July 4, 2013 Quick question, Is the flywheel nut or the primary drive nut a LH thread? What torque should they be done up to? Quote Link to comment Share on other sites More sharing options...
bullylover Posted July 5, 2013 Report Share Posted July 5, 2013 Hi littleblackflash. They are both normal threads, screw clockwise to tighten and anticlockwise to loosen. As far as torque goes my aging brain seems to remember 95 ft/lbs for each of them. They are both the same torque. I think that was out of a Clymer manual. I has been years since I have looked the torque for these nuts up though. Quote Link to comment Share on other sites More sharing options...
sherpa325 Posted July 5, 2013 Report Share Posted July 5, 2013 Clymer manual says 75 ft/lbs or 10 m/kgs Greg 1 Quote Link to comment Share on other sites More sharing options...
littleblackflash Posted July 5, 2013 Author Report Share Posted July 5, 2013 Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.