davdeborg Posted July 24, 2013 Report Share Posted July 24, 2013 hi again any one now the size of the ball bearing in the clutch actuator lever mines a bit crushed got it out but no way can I measure or match one up by it ordered all my stuff from inmotion today and forgot bearing, just wondering if anyone knows the size so hopefully pick one up tomorrow locally cheers Quote Link to comment Share on other sites More sharing options...
bondy Posted July 24, 2013 Report Share Posted July 24, 2013 not sure just ring inmotion back they will tell you. somthing ive never changed. Quote Link to comment Share on other sites More sharing options...
guys Posted July 24, 2013 Report Share Posted July 24, 2013 The original is about 5,4mm in diameter I think, but because mine was worn I put one in I had lying around which is 6mm. That's the largest one that will fit the hole. Quote Link to comment Share on other sites More sharing options...
sadlotus Posted October 9, 2013 Report Share Posted October 9, 2013 JUST done this today, I couldn't fit a 6mm, but a 5mm went in ok. In the parts book it says 5.5mm. Paul 1 Quote Link to comment Share on other sites More sharing options...
bondy Posted October 7, 2018 Report Share Posted October 7, 2018 Hello paul how did you get the old ball bearing out the clutch Arm? also how do you replace it as I have 1 that needs replacing Quote Link to comment Share on other sites More sharing options...
lorenzo Posted October 7, 2018 Report Share Posted October 7, 2018 Bondy - Check date of first post ....... 1 Quote Link to comment Share on other sites More sharing options...
bondy Posted October 8, 2018 Report Share Posted October 8, 2018 yes its a while ago I need to find out how to get the old flat bearing out and replace it with new Quote Link to comment Share on other sites More sharing options...
yamanx Posted October 8, 2018 Report Share Posted October 8, 2018 3/16" Quote Link to comment Share on other sites More sharing options...
nigel dabster Posted October 8, 2018 Report Share Posted October 8, 2018 Rod with grease on end or magnetic thin thing? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.