davelewis Posted September 24, 2013 Report Share Posted September 24, 2013 Hi Fantic fans the world over. I have just replaced the clutch lever assembly on my cherished 245 with an expensive but quality domino unit. Have also fitted a new Venhill clutch cable. The action now feels very nice and smooth. Very good disengagement, no drag but unfortunately the clutch now slips when in higher gears (3rd onwards) under load. The cable adjuster at the assembly end is screwed right in. What is my best option now - new plates, or is there something else simple? Thanks for any advice dave Quote Link to comment Share on other sites More sharing options...
zerorev3rev4 Posted September 24, 2013 Report Share Posted September 24, 2013 is there any slack in the cable it must be something you have done if was ok before Quote Link to comment Share on other sites More sharing options...
grib Posted September 26, 2013 Report Share Posted September 26, 2013 Sounds like you need to adjust the clearance at the pushrod: Unscrew the cap from the middle of the clutch cover, loosen the locknut on the adjusting screw and then back the screw out so it is about a quarter of a turn out from touching the end of the pushrod. Tighten the lock nut & screw the cap back in. Quote Link to comment Share on other sites More sharing options...
davelewis Posted September 27, 2013 Author Report Share Posted September 27, 2013 Thanks both. Will check on both suggestions Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.