davey64 Posted January 31, 2014 Report Share Posted January 31, 2014 Does anyone know the recommended gap between the low tension/lighting coil & the rotor. I've had to take them off the backplate to repair them and can't find any info on Google. It's the Femsa setup. Dave. Quote Link to comment Share on other sites More sharing options...
feetupfun Posted February 1, 2014 Report Share Posted February 1, 2014 I've never seen official instructions for this, but have had success with: Fix a piece of thin card or similar spacing shim to the outside surface of the laminations, set the stator coil towards the outward limit of its travel, set the screws with just the right tension so the coil can move if pushed, then fit and remove the flywheel carefully with no points (to make fitting the flywheel as easy as possible) but with the key in place, then tighten the stator coil screws Quote Link to comment Share on other sites More sharing options...
copemech Posted February 1, 2014 Report Share Posted February 1, 2014 I would think somewhere in the 0.6-1.00mm range would be normal for such things. Quote Link to comment Share on other sites More sharing options...
davey64 Posted February 1, 2014 Author Report Share Posted February 1, 2014 Thanks both, I'll try & set them up today. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.