toetoe Posted May 6, 2014 Report Share Posted May 6, 2014 I have read a few posts about re-greasing the swing arm bearings but how do i do it, do i have to take the bearings out to do this or is there a way of doing it with the bearings still in. Quote Link to comment Share on other sites More sharing options...
copemech Posted May 6, 2014 Report Share Posted May 6, 2014 I think that it would depend upon their condition. If they are not worn/rusted/ corroded I would flush them out with solvent, blow them out and re-pack with good grease. If they are knackered, knock them out and start fresh. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.