crazybond700 Posted September 29, 2014 Report Share Posted September 29, 2014 How can i remove the steering bar clamps from a gg pro 2008 tripple tree? Since the bolds are underneath the bar holder. Quote Link to comment Share on other sites More sharing options...
huski Posted September 29, 2014 Report Share Posted September 29, 2014 Remove the bars then drift out the pivot pin at the back of the clamp Quote Link to comment Share on other sites More sharing options...
crazybond700 Posted September 30, 2014 Author Report Share Posted September 30, 2014 ah thats a try worth. Quote Link to comment Share on other sites More sharing options...
crazybond700 Posted September 30, 2014 Author Report Share Posted September 30, 2014 (edited) Actually thought about it, but this does not solve my problem. Do i need to drill out the pins on the side? Because how am I going to mount them back on again? I can also just trow them away and mount others I have laying around, but would be a bit of a waste of the good clamps. /read your statement again and so my plan is the same as yours! Edited September 30, 2014 by crazybond700 Quote Link to comment Share on other sites More sharing options...
huski Posted September 30, 2014 Report Share Posted September 30, 2014 You don't need to drill them they're just pushed in you can tap them out with drift of smaller diameter than the pin then tap them back with a small hammer when you refit them Quote Link to comment Share on other sites More sharing options...
crazybond700 Posted October 1, 2014 Author Report Share Posted October 1, 2014 Ok, thanks. Will have a look next time when i am in the garage. They looked a bit like rivets to me, so I thought you couldn't get them out without damage to them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.