dr nick Posted January 14, 2004 Report Share Posted January 14, 2004 was going to buy a "O" ring chain yesterday but found that it wont fit my bike (not enough gap by the rear brake lever).So bought an "Iris" trial pro chain (coloured gold) Is there anything I should do to it before fitting or should I just put it on and away to go. Regards N Quote Link to comment Share on other sites More sharing options...
mark christopher Posted January 14, 2004 Report Share Posted January 14, 2004 i have run one on my mont and am very happy with it, i just fitted it and keep it lubed with chain spray Quote Link to comment Share on other sites More sharing options...
jtt Posted January 14, 2004 Report Share Posted January 14, 2004 I'd suggest you clean off all the "factory grease" as this is little more than packing grease. Best to remove it ) and put a coat of proper chain lube on. Hot soapy water and a good stiff brush usually works fine to clean it off. Quote Link to comment Share on other sites More sharing options...
jrsunt Posted January 14, 2004 Report Share Posted January 14, 2004 The Renthal R1 chain offers oring performance without sapping power and it cost around Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.