kevlarr Posted August 25, 2015 Report Share Posted August 25, 2015 Morning, I removed all the linkage a bearings to re grease and general maintenance at the weekend and now realise that I made one major mistake..... I didn't take any pictures of how it was before I took it apart. I have only had the bike a couple of months. Does any one have a picture of the correct way to re assemble please. I have nominated my self for **** of the week. Thanks Quote Link to comment Share on other sites More sharing options...
crazybond700 Posted August 25, 2015 Report Share Posted August 25, 2015 (edited) I dont have a picture (right now) but this might help you (last bit) https://www.youtube.com/watch?v=OhoF-tJVolU Idea is the same on all years. That are the parts, The single part or hole of the ''triangle'' goes on the shock. Than the upper part of the triangle goes to the swingarm, the lower goes (with the golden '''tube'' on the lower part of the triangle. THe lower parts attaches to the two arms. Also there are some washers, two go on the outside of the two arms, two inside, two inside the parts where the swingarm is attached to (so between trianle and swingarm). Edited September 2, 2015 by crazybond700 2 Quote Link to comment Share on other sites More sharing options...
kevlarr Posted August 25, 2015 Author Report Share Posted August 25, 2015 Many thanks Crazybond much appreciated. Quote Link to comment Share on other sites More sharing options...
crazybond700 Posted September 2, 2015 Report Share Posted September 2, 2015 Made a picture before serviceing Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.