blutaco Posted December 20, 2015 Report Share Posted December 20, 2015 Can anyone tell me the best way to seal a 199a's exhaust and rear silencer joint. Is there any particular tape to use? Cheers...John Quote Link to comment Share on other sites More sharing options...
bondy Posted December 20, 2015 Report Share Posted December 20, 2015 Hello blutaco the front manifold has a copper gasket that's that is needed make sure you tighten the nuts up even or you will bow the flange. To the rear there should be 2 small o rings on the tail off the club foot some times they work some time they don't i just smear a thick layer off sillicon round the tail put back together then leave to go off then peel the excess off sealed. 1 Quote Link to comment Share on other sites More sharing options...
blutaco Posted December 20, 2015 Author Report Share Posted December 20, 2015 Perfect, Bondy. Just tried it with some old engine o rings triple wrapped around the clubfoot. Very tight fit. Thank you! Quote Link to comment Share on other sites More sharing options...
bondy Posted December 20, 2015 Report Share Posted December 20, 2015 (edited) No problem been out on my 199A today rides very well not long had a total rebuild . Edited December 20, 2015 by bondy Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.