basketcase Posted March 25, 2016 Report Share Posted March 25, 2016 Hi, hope someone can help. I'm about to put the tyres on my '75 mk2 mar. There are 3 holes in the rim, one for the tyre retainer, one for the valve and the other one??? I only took one retainer off so am stuck as to what the third is for, any suggestions? Cheers, Nigel. Quote Link to comment Share on other sites More sharing options...
spen Posted March 25, 2016 Report Share Posted March 25, 2016 The other security bolt. (Tyre retainer). Quote Link to comment Share on other sites More sharing options...
dick Posted March 25, 2016 Report Share Posted March 25, 2016 Sounds like a rear wheel, you need more than one in the rear although one is probably plenty for the front. Quote Link to comment Share on other sites More sharing options...
basketcase Posted March 25, 2016 Author Report Share Posted March 25, 2016 Cheers, although I only took one out of the rear. Both wheels have the three holes so should I put another in the front. Will it upset the balance if I don't? I've never built up a trial bike before, just road bikes. This ones put up a few problems!! Quote Link to comment Share on other sites More sharing options...
cleanorbust Posted March 26, 2016 Report Share Posted March 26, 2016 If you run one security bolt in the front you will be fine. This was the standard set-up for trials bikes in the day. Don't worry about the effect on wheel balance, you definitely won't notice any difference. Quote Link to comment Share on other sites More sharing options...
basketcase Posted March 26, 2016 Author Report Share Posted March 26, 2016 Cheers all, now I just need to try and get the inner tube in! What a performance, there doesn't seem to be enough room to insert the valve! I'm going to leave it in the living room tonight so that it warms up and hopefully becomes more supple, just don't tell the wife! ? Quote Link to comment Share on other sites More sharing options...
cleanorbust Posted March 26, 2016 Report Share Posted March 26, 2016 (edited) I do it by getting one side of the tyre on to the rim then, holding the base of the valve, working it inside the tyre and lifting it to get as straight a shot as possible into the valve hole. You need flexible fingers for this. On my old twinshocks I used to enlarge the valve hole a bit with a round file to allow the valve to move a bit due to wheelspin when riding without ripping itself from the tube, but this also made inserting the valve a bit easier. Edited March 26, 2016 by cleanorbust Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.