brownie001 Posted July 19, 2016 Report Share Posted July 19, 2016 Hi, Im in the process of rebuilding the wheels on my 81 TLNW 320. What I forgot to do before stripping them was to check if the rim was in the middle of the hub or offset to one side. Anybody able to help ? Thanks, Phil Quote Link to comment Share on other sites More sharing options...
reginald Posted September 1, 2016 Report Share Posted September 1, 2016 Im getting some work done now and they used one wheel as a template so its been all specced up. Will share this with you but wont be till next week. 1 Quote Link to comment Share on other sites More sharing options...
petorius Posted September 2, 2016 Report Share Posted September 2, 2016 Just rebuilt a rear Bultaco. Can you not fit the hub back in the swingingarm, check chain alignment and then find the hub centre in the arm? Quote Link to comment Share on other sites More sharing options...
brownie001 Posted September 4, 2016 Author Report Share Posted September 4, 2016 Hi Petorius, I dare say there are ways and means but I thought that I am not the first person to rebuild some SWM wheels and someone out there would know the answer. For the record, I centred the rims, the rear looks fine but the front is just a bit too close to the righthand fork leg. Not much in it, about 5 mm is all it is. Could also be my bad centre calculation. Ciao, Phil Quote Link to comment Share on other sites More sharing options...
reginald Posted October 11, 2016 Report Share Posted October 11, 2016 sorry didnt get back to you - turned out the wheel was f#$ded so i bought a fantic 84 wheel - didnt measure but looks like the off set is equal 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.