richardgg280 Posted September 15, 2016 Report Share Posted September 15, 2016 Hi Forum I'm completely new to trial and not experienced with the engines. I was riding a 2007 model 125 Sherco trial where the wter temperature sensor blew out. I replaced the temperature sensor with a one that was lying in the workshop at the club (a screw in type instead of clip in). On removing the tank the bike was a total mess so I removed and cleaned the carb. Now I put everything back together and the bike is running but the kill switch doesn't stop the bike. I checked the switch for continuity and all OK but I'm not sure I re-connected the CDI correctly. Can anyone post a diagram of the electronics or take a photo from thier 2007 Sherco? Any ideas what may be wrong? Rich Quote Link to comment Share on other sites More sharing options...
copemech Posted September 16, 2016 Report Share Posted September 16, 2016 Switch has two wires. One connects to frame earth, other connect to CDI, black wire as I recall? Quote Link to comment Share on other sites More sharing options...
tony27 Posted September 16, 2016 Report Share Posted September 16, 2016 Black spade connector plugs into CDI unit, other wire connects to frame for earthing Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.