daz14 Posted September 23, 2016 Report Share Posted September 23, 2016 Hi everyone, I recently bought a 2015 250 beta evo and I have an ongoing problem with it running really hot, so much so that it is melting the plastic cover on the exhaust. The fan seems to run constantly as soon as it warms up. I have fitted jitsie high volume water pump kit and it has not made any difference. Has anyone experienced this issue and could possibly offer any solution or advice? thanks, Daz Quote Link to comment Share on other sites More sharing options...
petert Posted September 23, 2016 Report Share Posted September 23, 2016 Is it losing water, Darren? Quote Link to comment Share on other sites More sharing options...
totty79 Posted September 23, 2016 Report Share Posted September 23, 2016 Shine a torch through the radiator and check it's not full of mud. Also check for an air lock in the coolant, a 2015 may have a bleed screw on the head or you may need to stand the bike on the back wheel when filling it. 1 Quote Link to comment Share on other sites More sharing options...
thesolidman1 Posted September 23, 2016 Report Share Posted September 23, 2016 if it's an accessory plastic guard on the front of the pipe (not the silencer) it's normal for them to melt. Fan running constantly once it's warmed up is not that unusual either, depending on conditions. It's possible you don't have an issue. Quote Link to comment Share on other sites More sharing options...
daz14 Posted September 24, 2016 Author Report Share Posted September 24, 2016 Is it losing water, Darren? Does not seem to be losing any fluid Peter. if it's an accessory plastic guard on the front of the pipe (not the silencer) it's normal for them to melt. Fan running constantly once it's warmed up is not that unusual either, depending on conditions. It's possible you don't have an issue. I've never seen or heard of anyone else having a beta ( or any other bike) run so hot that it melts the front guard in this country. My Dad has the same guard on his 2013 and it has no signs of melting. Also the silencer gets overly hot. So much so I actually burnt my arm loading it onto the trailer after an event. Quote Link to comment Share on other sites More sharing options...
Crazed Weasel Posted March 20, 2020 Report Share Posted March 20, 2020 Hi Daz14, check that your carb jets are not partially blocked causing it to run really lean/hot. My 2013 EVO 2T (had sat for a while before I bought it) and it also ran really hot when I first got it, to the point that the engine was pinging anytime I gave it power under load (imagine the sound of a handful of marbles rattling violently in a coffee tin!). When I was diagnosing the issue: Like you I bought the larger waterpump impellor and it reduced but did not fix the issue. I also flushed and cleaned the radiator and replaced the coolant. I ensured that I was running the correct 1.5% of synthetic oil in the fuel, and I even tried running a colder sparkplug to reduce the engine temperature. After I removed both the pilot jet and the main jet from the carburettor, i noticed that both jets were partially blocked. After I cleaned them out and reinstalled, the bike immediately stopped pinging and overheating, is easier to start both cold and hot, and has twice the amount of 'snap' and power as it first had, completely more responsive and enjoyable to ride, with no overheating issues at all. I hope this helps you. Cheers Quote Link to comment Share on other sites More sharing options...
thall1 Posted March 20, 2020 Report Share Posted March 20, 2020 I did have a beta 4t that run hot... fan came on as normal but stayed on ... not unusual for a 4t but it spat out its water after being sat for a while on idle ... it was ok if the bike was actually moving...turned out the fan was running relatively slowly, so wasn’t giving the desired cooling...you could try comparing yours to another similar bike if possible Quote Link to comment Share on other sites More sharing options...
huski Posted March 20, 2020 Report Share Posted March 20, 2020 Does it start and run well with the expected power?Has the previous owner retarded the ignition timing to soften it and gone too far? 1 Quote Link to comment Share on other sites More sharing options...
b40rt Posted March 21, 2020 Report Share Posted March 21, 2020 What colour is the plug ? Quote Link to comment Share on other sites More sharing options...
carlos Posted March 21, 2020 Report Share Posted March 21, 2020 Yes 2 strokes can run real hot, lot's of good info above, (rectifiers not giving enough juice to run fan, blocked carb). My 2017 250 2T was also burning my leg, burnt a hole thru my pants, i took the plastic guard off and put 2 layers of aluminum automobile stick on tape on the underneath side of the plastic guard, as well as washers underneath to push the guard out 1/16th of an inch away from the pipe. No more burnt leg. Quote Link to comment Share on other sites More sharing options...
lineaway Posted March 21, 2020 Report Share Posted March 21, 2020 You guys are posting to a thread 3.5 years ago. Hello!!! 1 Quote Link to comment Share on other sites More sharing options...
b40rt Posted March 21, 2020 Report Share Posted March 21, 2020 1 hour ago, lineaway said: You guys are posting to a thread 3.5 years ago. Hello!!! It's a space time continuum question, you do know that ?? Quote Link to comment Share on other sites More sharing options...
lineaway Posted March 21, 2020 Report Share Posted March 21, 2020 Yes. I just love when a newbie reads through the forums and replies to old threads, like it was yesterday. Quote Link to comment Share on other sites More sharing options...
carlos Posted March 22, 2020 Report Share Posted March 22, 2020 19 hours ago, lineaway said: You guys are posting to a thread 3.5 years ago. Hello!!! Doesn't really matter, the Evo we ride today hasn't changed all that much since 2009, and is not likely to change that much in the future (other than bold new graphics, revised porting on the cylinder, and some fine tuning on that same old Saches rear shock!) 2 Quote Link to comment Share on other sites More sharing options...
b40rt Posted March 22, 2020 Report Share Posted March 22, 2020 1 hour ago, carlos said: Doesn't really matter, the Evo we ride today hasn't changed all that much since 2009, and is not likely to change that much in the future (other than bold new graphics, revised porting on the cylinder, and some fine tuning on that same old Saches rear shock!) Definition of revised - reconsidered and amended ! Does that mean changed back to how it used to be before it was improved ? 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.