Refresh 15 Sherco290 St

[master68]

I want to refresh my Sherco specifically regrease wheel bearings, steering head bearings, and swing arm bearings. Are there

Any guides, manuals, YouTube vids on the topic? I want to do myself but I have limited mechanical ability.

You thoughts would be appreciated.

[collyolly]

It is all quite straightforward for a mechanical mind, if as you say you have limited experiance can you give an example of what you do have experiance of ?

I cannot be specific about a Sherco as I have a Gasser but removing the swingarm to clean and grease the linkage is not a job for someone with limited experiance or as is probably the case a limited toolset. Also head bearings are not easy to get to then you have to reset the 'clearance' .

Have you got a club member or riding mate that has done their own maintainance that could lend a guiding hand ?

Take plenty of photos as you go and take your time until you are familiar with all the parts

Good luck

Edited December 24, 2016 by collyolly

[cascao]

It's not hard work. Take photos when disassembly it can be useful on reassembly

 

Lewisport usa have a good bit old manual that can help a lot

http://www.lewisportusa.com/manuals/sherc_11-21-09/sherco_setup_and_lubrication_guide.pdf

 

And is good having dogbone bushings before starting service. It's cheap and service will be perfect if you replace them. (16.18 and 16.19 on pag 19)

[master68]

Thank you for your input.