jsp Posted January 9, 2018 Report Share Posted January 9, 2018 Does anyone know anywhere I can buy the rubber seal/boot that fits under the front brake master cylinder cap ??? I’ve found the cap and the seal as a pair but I only wanted the seal Quote Link to comment Share on other sites More sharing options...
lsv Posted January 9, 2018 Report Share Posted January 9, 2018 (edited) Best of luck with that. I too just needed the rubber seal and was forced to buy the top as well - about £20 for what should have been about 10 bob for the rubber! The rubber in my opinion should not have swolen like it did on a late (2015) bike - it looked just like what happens if you put DOT4 seals in mineral oil so I don't think the rubber used is correct for the job - a possible safety issue that should be addressed by the manufacturers. I have stripped a lot of 30yr old Nissin (and 15yr old Grimeca) mastercylinders and never experienced this. Needelss to say I don't think much of this Braktec stuff. Edited January 9, 2018 by lsv typo 1 Quote Link to comment Share on other sites More sharing options...
jsp Posted January 10, 2018 Author Report Share Posted January 10, 2018 its a bit poor on the part of braktec, I'll have had one brake and one clutch rubber in the space of 8 months on a brand new bike Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.