snorky29 Posted August 18, 2019 Report Share Posted August 18, 2019 Hi, can anyone advise if there is a simple way to change the fork oil in a beta rev3 (2003) with out a strip down cheers Neil Quote Link to comment Share on other sites More sharing options...
2stroke4stroke Posted August 18, 2019 Report Share Posted August 18, 2019 I seem to remember spending about ten minuteson the operation: removing the front wheel and mudguard then, having removed the top nuts, sliding the stanchions out the yokes, upending them and pumping in to a collection vessel. Quote Link to comment Share on other sites More sharing options...
snorky29 Posted August 18, 2019 Author Report Share Posted August 18, 2019 many thanks for that ...i presume you just put the desired amount of oil in each leg at the open end(nut removed) and just tighten things back up is it Quote Link to comment Share on other sites More sharing options...
technowaldo Posted August 18, 2019 Report Share Posted August 18, 2019 Best to pull them apart and flush them out as there is always oily gunge lying at the bottom of the legs if putting fresh oil in Quote Link to comment Share on other sites More sharing options...
2stroke4stroke Posted August 19, 2019 Report Share Posted August 19, 2019 Can be flushed by pumping fluid whilst in one piece, it may need more than one go. I used to use paraffin and it did not seem to affect seals. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.