DonMoto71 Posted March 20, 2021 Report Share Posted March 20, 2021 Hi, just replaced the wobbly wheel bearings but the rear wheel of my 199 Sherpa is still not fixed properly when I fasten the wheelnut. Washer behind wheelnut touches the thicker part of the axle after the thread before the rear wheel is fully tightened. Of course had I checked the parts book but I am still unsure if therr is something missing. I have, beginning from the right. Head of axle washer chain adjuster wishbone speedo drive wheel bearing distance wheel bearing drum brake hub thick washer wishbone chain adjuster thin washer (in diameter if thread) Nut Am I missing something? Raoul Quote Link to comment Share on other sites More sharing options...
woody Posted March 20, 2021 Report Share Posted March 20, 2021 The thread on the spindle is a smaller diameter than the spindle shaft. If you remove the nut and washer and just eave the chain adjuster on, you will see that the spindle shaft extends past the adjuster. You need a washer that is the correct ID to slip over the shaft itself not just the threads and the washer also needs to be thick enough that none of the shaft is exposed. If it isn't set up like this the nut will reach the end of the thread and tightens against the spindle shaft itself, not the swingarm From your parts list it looks as though you have the thick washer on the wrong side 1 1 Quote Link to comment Share on other sites More sharing options...
DonMoto71 Posted March 20, 2021 Author Report Share Posted March 20, 2021 Ok, that’s the help I was looking for! I wanted to know the correct order before I started to sort it (what is not complicated of course) Raoul Quote Link to comment Share on other sites More sharing options...
DonMoto71 Posted March 22, 2021 Author Report Share Posted March 22, 2021 So, much better niw if course, but I am still unsure about the order and especially number if “things” in the course of the rear axle. If someone could check out his rear axle (especially around the speedometer drive) it would still be highly appreciated Raoul Quote Link to comment Share on other sites More sharing options...
lorenzo Posted March 22, 2021 Report Share Posted March 22, 2021 (edited) Raoul - From your original post, it looks like you have a thick washer between the brake plate and swing arm ? Brake plate should go up against swing arm lug - NO washer.... Thickness/width of speedo. drive (or spacer replacing it) should be 33mm. - between wheel bearing and swing arm lug on r/h side. HTH Edited March 22, 2021 by lorenzo 1 1 Quote Link to comment Share on other sites More sharing options...
DonMoto71 Posted March 25, 2021 Author Report Share Posted March 25, 2021 Lorenzo, thanks a lot, this helps with making a speedo replacement! Washer has found to it's correct place already and I just found a sleeve which goes somewhere around the speed drive which obviously fell down and rolled away when I took the wheel off the bike... I assume it will be perfect again when I fit that sleeve AND have everything in the right order 😄 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.