donmurray Posted February 15, 2006 Report Share Posted February 15, 2006 My 315 had a clutch that dragged so bad you had to push off and then click it in gear when it was cold/first started. Then after it warmed the it would drag badly unless you blipped the throttle every 3 seconds. Also hard to modulate. Tried the Silkolene oil, but not better. I finally bit the bullet and installed new standard friction disk which are a mix of cork and paper fibre. Also went to the recommended Elf oil. Just to make sure I bleed the hydraulics. Clutch works fine now. A little clunk as it goes in gear, but the bike does not move. Smooth progressive engagement. It now has about 3 hours since the rebuild and still works fine. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.