garydwall Posted May 16, 2022 Report Share Posted May 16, 2022 Hello could someone please advise me. What is the best way to remove the oil seal crankshaft on the magneto side. I want to remove the crankshaft bearing to replace it. Does the seal get pushed out at the same time the bearing is pushed out? Thanks in advance. Gary Quote Link to comment Share on other sites More sharing options...
arnoux Posted May 16, 2022 Report Share Posted May 16, 2022 Hi Gary You need to split the cases, and remove the LHS Main Bearing to gain access to that seal. Once the LHS crank main bearing is removed you can get that seal out by pressing it towards the centre line of the bike. They do not come out together. Quote Link to comment Share on other sites More sharing options...
garydwall Posted May 17, 2022 Author Report Share Posted May 17, 2022 Thank you very much. Got bearing and seal out now... God bless blind side pullers. Cheers for the advice Quote Link to comment Share on other sites More sharing options...
d2w Posted May 20, 2022 Report Share Posted May 20, 2022 (edited) FYI ... I've not done the work you're doing ... but I >believe< that the bearing is "special" in that there's an oil passage hole in the outer-race, and it must be aligned with an oil feed "pipe" in the casing. It is possible that I've mixed-up that requirement for alignment with the clutch-side bearing; I know one of them is "special". Just be mindful of the possible requirement. Dale Edited May 20, 2022 by d2w 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.