drop5 Posted March 1, 2006 Report Share Posted March 1, 2006 does anyone know what the torque setting is for the flywheel nut on a 2000 rev 3. I,ve read some of the posts about shearing the woodruf key, now i'm worried.up till now i've just done it up very tight. Quote Link to comment Share on other sites More sharing options...
andy_290 Posted March 1, 2006 Report Share Posted March 1, 2006 Don't know about Beta's, my Sherco's 72 ft/lbs, can't imagine the Beta's much different. Quote Link to comment Share on other sites More sharing options...
bob Posted March 2, 2006 Report Share Posted March 2, 2006 I read on the SSDT prep list that the flywheel needs to be done up to just over 140 Nm which was is a helluva lot if you try it, i set a torque wrench and no matter how much i tried i couldn't quite get it to this so i whacked it a couple of times with a rubber mallet, i was having trouble keeping the flywhhel from turning. Bob Quote Link to comment Share on other sites More sharing options...
sirdabsalot Posted March 2, 2006 Report Share Posted March 2, 2006 The torque value I have for a 2003 Rev3 is 140Nm, or 103ft/lbs. Another method is to tighten it 'til it breaks, then back off half a turn (experience talking here). Cheers, Richard Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.