lonewolf Posted March 4, 2023 Report Share Posted March 4, 2023 Beta evo 250 recently cleaned carb & runs fine only issue is I noticed the air screw is all the way in. Will this be fine. I screwed it out 1.5 turns & it made it run a little worse. Quote Link to comment Share on other sites More sharing options...
feetupfun Posted March 5, 2023 Report Share Posted March 5, 2023 That indicates that it probably has one of these things happening: Pilot jet or pilot jet passage restricted. Too small a pilot jet. Air leaking into the motor somewhere other than through the carby venturi. If it didn't have the problem before you cleaned the carby then it's not option 2. 3 Quote Link to comment Share on other sites More sharing options...
arthritic Posted March 6, 2023 Report Share Posted March 6, 2023 I'd first check the mixture screw spring, washer and rubber are all there and in the right order. Quote Link to comment Share on other sites More sharing options...
lonewolf Posted March 6, 2023 Author Report Share Posted March 6, 2023 Pilot jets are all clean & blown out. Funny thing is it runs just the same. When you rev it revs come back down nice & steady. Nothing really changes when you screw it out when it's ticking over revs don't increase. I ran it on sat all the way in & 1.5 out & didn't really notice any thing different between the settings. Temp was around 5 degress C. Quote Link to comment Share on other sites More sharing options...
lonewolf Posted March 6, 2023 Author Report Share Posted March 6, 2023 Pilot cleaned & also the small passage in the body cleaned out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.