Al1 Posted August 28, 2023 Report Share Posted August 28, 2023 Anyone got any tips for threading a new brake hose through the swinging arm ? Can it be done without removing the swinging arm ? Any tips appreciated Quote Link to comment Share on other sites More sharing options...
lineaway Posted August 28, 2023 Report Share Posted August 28, 2023 It goes through fairly easy without removing the swingarm, did one a few months back. Run string or wire to pull with. 2 Quote Link to comment Share on other sites More sharing options...
jonnyc21 Posted August 29, 2023 Report Share Posted August 29, 2023 When I did the one on our Gas Gas I just did what Lineway is saying, tied a string to one side of my current hose before pulling it and then used that to pull things back after the fact. If you already have the old hose pulled out then you could use something like a wire cloths hanger to fish a string through it? Good luck. 1 Quote Link to comment Share on other sites More sharing options...
baldilocks Posted September 28, 2023 Report Share Posted September 28, 2023 When I did this on my 2013 I had to remove the banjo from one end, I put clung film round it to stop dirt getting in the hose. It was a venhill hose but I couldn't get it through the swinging arm with the banjo on Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.