E19HAD Posted September 25, 2023 Report Share Posted September 25, 2023 Hi, I am on my second Cota 349 build (for my sins) and this one has really gave me a head spin. The engine has just been rebuilt and all I needed to do was connect the electrics and that was it, job done... Er no chance! Brand new points, condenser, stator check(good), new coil, new plug cap and new plug, but no spark. Coil on frame had a very good earth with no paint in between, all engine mounts have good earth as well. Can anyone on here throw me a bone to what I might have to do to get a spark please? Quote Link to comment Share on other sites More sharing options...
reggie Posted September 25, 2023 Report Share Posted September 25, 2023 If you have a kill switch wired in remove it and check spark again. Check the condenser, sometimes they can become a dead short. Good luck. Quote Link to comment Share on other sites More sharing options...
E19HAD Posted September 25, 2023 Author Report Share Posted September 25, 2023 Hi, no kill switch and new condensor 😕 Quote Link to comment Share on other sites More sharing options...
lemur Posted September 25, 2023 Report Share Posted September 25, 2023 Photos of things like the points might help somebody spot an issue. I always meter and scope trouble shoot starting with the source of power and work down stream until you find the missing link. Alternator first, fuse next, rectifier and regulator if so equipped, Are you setting your points using a meter to make sure it has a good make and break? That will confirm if you have the points wired correctly. Condenser is the hardest thing to meter test but a new one is just as good. Ignition coil needs to be meter tested on both sides as per the service manual, resistance will be very low on the one side in the range of an ohm or three and exponentially greater on the other, no continuity or incorrect ohm reading on either side is a problem. Does your spark lead wire, plug cap and spark plug all have the correct resistance or did you change something there? Quote Link to comment Share on other sites More sharing options...
BCL100 Posted October 24, 2023 Report Share Posted October 24, 2023 Hello, does your bike also have an automatic advance and regard ? If it has take a look at it, sometimes they get dirty with oil ECT . When this happens you will get no spark ! In the past I have treated this with a very generous dose of WD40 and problem solved . kind regards Bernard . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.