lotus54 Posted 21 hours ago Author Report Share Posted 21 hours ago I got a quote from a different outfit. Looks like I could sell them for about $600 in Titanium, with all the pins included. I am ordering one set and I will see how the quality is and do a final on making sure my design is correct. I already fit my 3D printed parts and all seems good, but of course I cannot put any sort of load on the plastic parts at all. This is good news. The main link bearings is additional cost, the ones I got so far were not cheap- but I likely could source the same ones someplace else for less. It will have small grease fittings on all the pins. Quote Link to comment Share on other sites More sharing options...
larro Posted 19 hours ago Report Share Posted 19 hours ago I presume you are not in the UK. Quote Link to comment Share on other sites More sharing options...
lotus54 Posted 19 hours ago Author Report Share Posted 19 hours ago 38 minutes ago, larro said: I presume you are not in the UK. No, I am in the States. Quote Link to comment Share on other sites More sharing options...
larro Posted 19 hours ago Report Share Posted 19 hours ago Hmm. Postage to the UK. That's why i asked where you are based. Thanks. Quote Link to comment Share on other sites More sharing options...
lotus54 Posted 18 hours ago Author Report Share Posted 18 hours ago 27 minutes ago, larro said: Hmm. Postage to the UK. That's why i asked where you are based. Thanks. I get parts from the UK for my Lotus all the time. Usually the costs are not that much at all (a full chassis on the other hand cost more to ship than it cost). The Ti is pretty light. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.