steam Posted April 15, 2006 Report Share Posted April 15, 2006 1 I have removed rear wheel bearings and found on floor a dish shaped spacer with the hole diameter the same as the wheel hub spacer .i am not certain where it should be fitted or if there should be two. 2 Also do i need to pack grease into the hub centre as the bearings are sealed? 3 Also i have taken a very small nick out of one spoke with a hacksaw ----does anyone think spoke will break or is it worth chancing it? Quote Link to comment Share on other sites More sharing options...
lewis_gasgas Posted April 15, 2006 Report Share Posted April 15, 2006 (edited) 1. not sure which bit you mean of a dish shape maybe take a pic ? 2. Theres no need to grease the hub centre as it just uses the bearings if you get what i mean /the wheel bearings wont need regreasing simply because i dont think you can so if theres play get some new ones or if they look nackered. 3. Probably would be advisable to get another spoke incase it broke while your riding or a trial ect. Edited April 15, 2006 by Lewis-GasGas Quote Link to comment Share on other sites More sharing options...
jools Posted April 16, 2006 Report Share Posted April 16, 2006 your second point; if you flick the bearing rubber covers/seal off with a small screw driver and apply some grease directly onto the bearings ( i use copper grease) and pop the seals back on (put the bearings in the hub dry), then just put some grease onto the axle when putting the back wheel on. it just makes it easier to get it back off when you need to. third point; depends how bad it is! a spoke is pennies but putting it on is a ball ache. you might get away with leaving it. Quote Link to comment Share on other sites More sharing options...
steam Posted April 16, 2006 Author Report Share Posted April 16, 2006 here are pictures of the dish shape spacer (damaged) for 1995 gas gas which fits somewhere on rear wheel bearing/ hub spacer but do not know where in relation to bearings or which side of wheel. any help appreciated. Quote Link to comment Share on other sites More sharing options...
lowbrow Posted April 17, 2006 Report Share Posted April 17, 2006 Does this washer fit over the central spacer? If so its to help keep things lined up to make it easier to push the spindle through. Looks like its had a hard life whatever it is! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.